![op-amp-challenge:-compare-op-amps,-by-listening-to-them-[hackaday]](https://i0.wp.com/upmytech.com/wp-content/uploads/2023/05/122356-op-amp-challenge-compare-op-amps-by-listening-to-them-hackaday.jpg?resize=800%2C445&ssl=1)
Op-Amp Challenge: Compare Op-Amps, By Listening To Them [Hackaday]
In the world of audiophilia there are arguments that rage over the relative merits of particular components. Sometimes this can reach silly levels as in the high-end ALPS pot we once saw chosen as a volume control whose only task was to be a DC voltage divider feeding a pin on a DSP, but there are moments where such comparisons might have a bit of merit. To allow the comparison of different op-amps in a headphone amplifier, [Stephan Martin] has created a stereo amplifier board complete with sockets to take single or dual op-amp chips.
The circuit is based upon a design from the 1990s which as far as we can see is a pretty conventional non-inverting amplifier. It has an on-board op-amp to create a virtual ground, and three sockets for either two single or one dual op-amp to create a stereo headphone amplifier.
So the burning question is this: will you notice a difference? We’re guessing that assuming the op-amps under test are to a sufficient specification with a high enough impedance input and enough output current capability, the differences might be somewhat imperceptible without an audio analyser or the hearing of a ten-year-old child.
Need more of an audio fix? Try our Know Audio series.
